ARCHIVED FORUM (READ-ONLY)  ·  about this archive
3DBatix Forum Index

foamies pushrods
4 posts
 
   3DBatix Forum Index -> Foamies
 
Author Message
jmay



Joined: 01 Aug 2004
Posts: 5

PostPosted: Sun Aug 08, 2004 1:24 am    Post subject: foamies pushrods  

So im building my first foamie and I was installing the pushrod.. The plans say to use .032 wire but this seem to be to flimsy the wire seems to bend all around. And with the slightest amount of force on the control surface you can move it around with out moving the servo.
My question is am I alone? Can anybody show me some pic of what there doing? And how about using carbon fiber rod instead? Please help…
Thanks , Jmay
Back to top  
Meyrick
Site Admin


Joined: 15 Apr 2004
Posts: 678
Location: Fremont, CA

PostPosted: Sun Aug 08, 2004 6:43 pm    Post subject:  

I use a 3mm carbon tube and then I cut 3 inches of the .032 wire. I CA about 2 inches of it in the tube so only about an inch of wire is sticking out. Do the same on the other side of the tube. This works great for me.
_________________
--Meyrick--
Back to top  
Albruno



Joined: 08 Sep 2004
Posts: 1
Location: Lakewood, N.J.

PostPosted: Wed Sep 08, 2004 12:40 pm    Post subject: Pull-pull ?  

What are you using on your rudder? one rod or pull-pull ?
Back to top  
Meyrick
Site Admin


Joined: 15 Apr 2004
Posts: 678
Location: Fremont, CA

PostPosted: Wed Sep 08, 2004 1:14 pm    Post subject: Re: Pull-pull ?  

Albruno wrote:
What are you using on your rudder? one rod or pull-pull ?


Just one rod. Works just fine.

_________________
--Meyrick--
Back to top  
 
   3DBatix Forum Index -> Foamies All times are GMT - 8 Hours

Powered by phpBB 2.0.6 © 2001, 2002 phpBB Group

blueGray theme by Nuttzy
Restored from the Internet Archive, 2026 · about this archive