ARCHIVED FORUM (READ-ONLY)  ·  about this archive
3DBatix Forum Index

Repairing & Building Foamies with Depron
4 posts
 
   3DBatix Forum Index -> Workshop
 
Author Message
CCFlyer



Joined: 15 Sep 2004
Posts: 10
Location: Arroyo Grande, CA

PostPosted: Fri Nov 12, 2004 5:25 pm    Post subject: Repairing & Building Foamies with Depron  

Hey Guys:

I bought some Depron to repair and maybe scratch build foamies. Have a couple of questions:


Where can you buy/ download plans for foamies?

What type of glue is used to glue carbon rods in slots for spars, stiffeners, etc?

Finally, what's the best way to cut bevels for the control surfaces?


Thanks for any help!

_________________
Scott
Back to top  
Meyrick
Site Admin


Joined: 15 Apr 2004
Posts: 1316
Location: Fremont, CA

PostPosted: Fri Nov 12, 2004 8:16 pm    Post subject: Re: Repairing & Building Foamies with Depron  

Where can you buy/ download plans for foamies?
You can download plans here free and some from www.foamyfactory.com.

What type of glue is used to glue carbon rods in slots for spars, stiffeners, etc?
You can use either RC56 Glue or Thick Foam CA. I've used both and either works great.

Finally, what's the best way to cut bevels for the control surfaces?
I double bevel using dremel bit #DRE178 with a router guide and using a straight edge. I don't cut all the way thru the foam, just leave some skin and put blenderm tape on top.

_________________
--Meyrick--
Back to top  
3D-kid330



Joined: 14 Nov 2004
Posts: 391
Location: Fremont, CA

PostPosted: Mon Nov 15, 2004 8:25 pm    Post subject:  

Also www.3DFoamy.com . big grin You can buy full size plans and download plans.
_________________
Lower??!!
Back to top  
3dbatixkid
Moderator


Joined: 15 Apr 2004
Posts: 1178
Location: Sunnyvale, CA

PostPosted: Wed Nov 17, 2004 9:50 am    Post subject:  

Where can you get plans? right here on 3dbatix of course! Razz laughing The dremel hinging is pretty nice, but i still dont think it works as well as just blenderm tape in terms of surface deflection. I double bevel all my control surfaces and TEs and then tape them together. Just make sure that you clean the surface with alcohol before putting the tape on.
_________________
Zak West

www.DesertAircraft.com

www.Smart-Fly.com

www.DarrolCady.com

www.CoolRunningUSA.com

www.TanicPacks.com
Back to top  
 
   3DBatix Forum Index -> Workshop All times are GMT - 8 Hours

Powered by phpBB 2.0.6 © 2001, 2002 phpBB Group

blueGray theme by Nuttzy
Restored from the Internet Archive, 2026 · about this archive