ARCHIVED FORUM (READ-ONLY)  ·  about this archive
3DBatix Forum Index

PCM or PPM?
4 posts
 
   3DBatix Forum Index -> Gear Talk
 
Author Message
Gezoid



Joined: 24 May 2004
Posts: 83
Location: UK

PostPosted: Sun Nov 28, 2004 1:51 am    Post subject: PCM or PPM?  

Do you guys use PCM? I've always used PPM, but this plane has cost a bucket load and I was wondering, should I use it... What about these stories of lock out?

Friend of mine gave me a fantastic demonstration with a JR PCM receiver the other night. He had the PCM system all hooked up and running and then switched on another transmitter on THE SAME frequency. The PCM system continued to operate cleanly! If the other tranny got too close it just locked it out - but - it took a little while to reset when the other tranny was moved away again, but the PCM JR was an old set.

We have loads of old guys at the field who fly really old equipment. I figure most of these old trannys are maybe dirty and a little out of band and we do get glitches when they're flying.

I'd hate to lose the ship to interference, but then again, I'd hate to lose it to PCM lockout! So whaddya think?
Back to top  
Meyrick
Site Admin


Joined: 15 Apr 2004
Posts: 866
Location: Fremont, CA

PostPosted: Sun Nov 28, 2004 9:37 am    Post subject:  

PCM all the way, I use them on all my gas & glo ships. If they only had tiny PCM RXs, I'd use them on my foamies also.
_________________
--Meyrick--
Back to top  
3dbatixkid
Moderator


Joined: 15 Apr 2004
Posts: 672
Location: Sunnyvale, CA

PostPosted: Sun Nov 28, 2004 5:49 pm    Post subject:  

The code that is transmitted between the transmitter and the receiver in PCM mode is harder to interfere with. Also, PCM allows you the lock out feature like you have seen, instead of the wild glitching that you get with FM(PPM). I use PCM in all my stuff.
_________________
Zak West
Team DA

Desert Aircraft

Smart Fly

Fromeco Avionics

Stick and Rudder Photos
Back to top  
Gezoid



Joined: 24 May 2004
Posts: 83
Location: UK

PostPosted: Mon Nov 29, 2004 9:32 am    Post subject:  

PCM it is then! Cool
Back to top  
 
   3DBatix Forum Index -> Gear Talk All times are GMT - 8 Hours

Powered by phpBB 2.0.6 © 2001, 2002 phpBB Group

blueGray theme by Nuttzy
Restored from the Internet Archive, 2026 · about this archive