| |
| Author |
Message |
mikey
Joined: 28 Nov 2004 Posts: 109 Location: Greenville, TX
|
Posted: Fri Jan 20, 2006 9:05 am Post subject: Cans or Muffler?? |
|
|
I have decided that I am going to get qq yak 102" was planning to get the supper extera but my dad has talked me out of getting that for my first gas plane. So my question is I want this thing to have great smoke I am going to get the 3w QQ106 should I use cans or mufflers on it. Also what smoke system is the best for this engine I want the fire department to be called out every time I fly.
Thanks Guys
Mikey
P.S. Zak your coming to Texas right you are welcome at my house any time. |
|
| Back to top |
|
 |
sr1969
Joined: 04 Oct 2004 Posts: 5 Location: Fremont, CA
|
Posted: Fri Jan 20, 2006 1:01 pm Post subject: Re: Cans or Muffler?? |
|
|
I think the question of cans vs. std mufflers should really boil down to your needs. If you plan to fly at fields with enforced noise restrictions (usually <100 db) then the cans are a good way to go. Keep in mind that cans are considerably more expensive, they weigh more, and are a much more complicated installation than a set of mufflers. Although (i have read that) some of the newer cans will provide a slight performance increase, they always carry a (some consider to be considerable) weight penalty (from what I have read somewhere around 1-1/2 to 2 lbs). IMO, if noise is not an issue for you then save time, money, and weight and go with a std set of mufflers.
As far as smoke is concerned, not sure how the cans come (and I am sure they are all different) but most of the big name engine manufacturer's mufflers come pre-tapped for smoke. In my case I'm currently running a DA-100. Mufflers came setup for smoke. As far as smoke systems are concerned I have owned both Slimline and Sullivan's smoke packages and had good experience with both. Both systems could produce gobs of smoke, but usually you run them at about 30%-50% of full speed in order to get the smoke to last.
There are so many variables that can affect smoke systems (muffler type, where its tapped, how the tubing is run, engine exh temp, etc.), too many to list here. Right now I am running the Slimline (Pro) system on my DA-100. I just followed the directions that came with it for installation and was off and running. After the first test flight I ended up dialing the smoke back to about 40% (if I remember right). The nice thing about these new sytems is that not only can you dial the flow rate right through your radio, but you can link the smoke to your throttle. The higher the throttle, the higher the flow and visa versa for low throttle. Actually I have mine dialed to go to zero flow below about 20% throttle. You need to do this because the smoke will actually kill the motor at low throttle.
One of the most important things to note when installing smoke on a twin cylinder motor is to keep the length of the fuel tubing EXACTLY the same between the two mufflers. Otherwise the muffler with the shorter tubing will always get more flow than the muffler with the longer tubing, and it doesn't take much of a difference in length to create a drastic difference in the amount of smoke produced on each side.
Hope this helps. I'm sure plenty of others (with more experience than I) will chime in on this one. I wish you the best of luck.
P.S. - great choice of birds, I have read and heard a lot of great things about the QQ Yak. I'm sure you'll love it! _________________ What goes up, must come down (it's what happens in between the two that counts!) |
|
| Back to top |
|
 |
Meyrick Site Admin

Joined: 15 Apr 2004 Posts: 1316 Location: Fremont, CA
|
Posted: Fri Jan 20, 2006 8:55 pm Post subject: Re: Cans or Muffler?? |
|
|
| mikey wrote: |
P.S. Zak your coming to Texas right you are welcome at my house any time. |
You don't want Zak in your house. He STINKS! All he eats are BEAN Burritos.... _________________ --Meyrick-- |
|
| Back to top |
|
 |
Meyrick Site Admin

Joined: 15 Apr 2004 Posts: 1316 Location: Fremont, CA
|
Posted: Fri Jan 20, 2006 8:56 pm Post subject: |
|
|
I have the 106 and it's a powerful motor. Just get muffs for now to keep it light and it's easier to tune the motor. With cans, you would have to deal with mid range issues. _________________ --Meyrick-- |
|
| Back to top |
|
 |
fly boy 1

Joined: 12 Nov 2004 Posts: 286 Location: Milwaukee,WI
|
Posted: Sat Jan 21, 2006 8:59 am Post subject: |
|
|
| Meyrick wrote: | | I have the 106 and it's a powerful motor. Just get muffs for now to keep it light and it's easier to tune the motor. With cans, you would have to deal with mid range issues. |
Don't forget ignition issues. But thats 3W specific. I would go DA 100, but I'm biased haha. But to not to hijack the thread, standards are the best. They're light powerful, and they don't do that midrange crap like cans. The only downside is standards are a little louder. _________________ Team Greenfield News and Hobby
Dave Partick 27% Extra 330L
Raptor 50
TOC1 30% Yak 54
Judge 540
Shocky Extra
http://www.greenfieldnewsandhobby.com |
|
| Back to top |
|
 |
mikey
Joined: 28 Nov 2004 Posts: 109 Location: Greenville, TX
|
Posted: Sat Jan 21, 2006 8:07 pm Post subject: Re: Cans or Muffler?? |
|
|
| Meyrick wrote: | | mikey wrote: |
P.S. Zak your coming to Texas right you are welcome at my house any time. |
You don't want Zak in your house. He STINKS! All he eats are BEAN Burritos.... |
Taco Bell is off limits Zak when you come to Texas
I have not got the engine I am not biased to 3W. The reason I was going to get it because they were going to have a set of cans made specifically for the yak but that has not happened yet. So a DA is not out of the possibility. Back to the cans how much power do they add vs weight it is enough to over come the weight? What one do you guys think sounds better and the smoke cans vs muffler what one will out put more smoke? |
|
| Back to top |
|
 |
fly boy 1

Joined: 12 Nov 2004 Posts: 286 Location: Milwaukee,WI
|
Posted: Sun Jan 22, 2006 6:54 am Post subject: |
|
|
The main reason people put cans on the bigger planes is because the standards are pretty loud. The cans don't seem to add any power, but a pipe will.As far as smoke, they should both work well. So, the cans will be better for imac, just because they will be quieter, but the standards have a better throttle responce, so it's a trade off. _________________ Team Greenfield News and Hobby
Dave Partick 27% Extra 330L
Raptor 50
TOC1 30% Yak 54
Judge 540
Shocky Extra
http://www.greenfieldnewsandhobby.com |
|
| Back to top |
|
 |
3dbatixkid Moderator

Joined: 15 Apr 2004 Posts: 1178 Location: Sunnyvale, CA
|
Posted: Sun Jan 22, 2006 1:43 pm Post subject: |
|
|
Hey mikey,
For the QQ yak, go with stock muffs on a DA 100. It will be MORE than enough power. I think the only reason that I would personally put cans on a plane that size is if there were noise limitations. I have not found the throttle response of cans to be all that great, and the added weight can be put to better use...like a smoke system  _________________ Zak West
www.DesertAircraft.com
www.Smart-Fly.com
www.DarrolCady.com
www.CoolRunningUSA.com
www.TanicPacks.com |
|
| Back to top |
|
 |
mikey
Joined: 28 Nov 2004 Posts: 109 Location: Greenville, TX
|
Posted: Sun Jan 22, 2006 3:30 pm Post subject: |
|
|
Ok then I am going with Da with stock mufflers thanks for all the input guys.
Zak no coment on the texas trip? |
|
| Back to top |
|
 |
3dbatixkid Moderator

Joined: 15 Apr 2004 Posts: 1178 Location: Sunnyvale, CA
|
|
| Back to top |
|
 |
Tampa Bay Flyer

Joined: 09 Dec 2005 Posts: 22 Location: Tampa, Florida
|
Posted: Mon Jan 23, 2006 6:34 am Post subject: |
|
|
Hey Mikey, I have a Sullivan "Skywriter" smoke system like sr1969 was talking about for sale. Only used 2 times and removed from my TOC Yak.
Didn't want to mess with the clean-up. Smoke pump, back flow preventer, & 11.1 volt Li-ion battery by TBM for $70.00 _________________ Monty,
QQ 72" Yak
TOC 30% YAK
Comp Arf 40% SuperX |
|
| Back to top |
|
 |
sr1969
Joined: 04 Oct 2004 Posts: 5 Location: Fremont, CA
|
Posted: Mon Jan 23, 2006 9:13 am Post subject: Sullivan Skywriter |
|
|
Sounds like a good deal on the Skywriter, I had one in my 33% Edge and it worked great. I would have bought another for my current bird but they were out of stock at the time, being impatient I bought the Slimline which has turned out to work great also. I really don't think you can go wrong with either system (I have seen TME's newer system and it also appears to perform well). One item I would suggest with either system, they both claim to be "immune" to airframe vibration and allow direct installation to the airframe. I did so with my Skywriter and broke one of the resistors off from the vibration. I sent it in and they were great about fixing it (no charge) and sent it back in about a week. But, I would suggest that you NOT hard mount them on the airframe but treat them just like any other electrical component and put 1/4"-1/2" of foam under them and use velcro to hold them in place. My Slimline came with thumbscrews so you could hard mount it to the airframe but I threw them out and isolated it. I'm glad I did because I had someone share a similar experience (vibration damage) on the Slimline system also. So it appears that neither system is immune to vibration.
S _________________ What goes up, must come down (it's what happens in between the two that counts!) |
|
| Back to top |
|
 |
| |