ARCHIVED FORUM (READ-ONLY)  ·  about this archive
3DBatix Forum Index

Cutting Tool
4 posts
 
   3DBatix Forum Index -> Foamies
 
Author Message
3Dwannabe



Joined: 30 May 2005
Posts: 6
Location: Kunsan AB, South Korea

PostPosted: Sun Jun 26, 2005 4:18 am    Post subject: Cutting Tool  

Hey Meyrick where did you get that tool to cut out slots for carbon fiber rods in you foamies. Also what is it called.

Thanks

Shane
Back to top  
craigman



Joined: 31 May 2004
Posts: 105
Location: Redding, CA

PostPosted: Sun Jun 26, 2005 9:51 am    Post subject:  

Shane,,
i think this is what your looking for.

http://www.3dbatix.com/forum/viewtopic.php?t=302

Hope this helps!

Craig
Back to top  
3Dwannabe



Joined: 30 May 2005
Posts: 6
Location: Kunsan AB, South Korea

PostPosted: Sun Jun 26, 2005 4:45 pm    Post subject:  

Thanks Craig appreciate the help.
Back to top  
Meyrick
Site Admin


Joined: 15 Apr 2004
Posts: 1314
Location: Fremont, CA

PostPosted: Sun Jun 26, 2005 6:45 pm    Post subject:  

The bit for the wing tube spar is Dremel bit#192 and the bit to cut the bevel for the control surfaces is Dremel bit#178.


hingebit1.jpg
 Description:
bit#178
 Filesize:  58.39 KB
 Viewed:  239 Time(s)

hingebit1.jpg



carbonbit.jpg
 Description:
bit#192
 Filesize:  52.1 KB
 Viewed:  239 Time(s)

carbonbit.jpg



_________________
--Meyrick--
Back to top  
 
   3DBatix Forum Index -> Foamies All times are GMT - 8 Hours

Powered by phpBB 2.0.6 © 2001, 2002 phpBB Group

blueGray theme by Nuttzy
Restored from the Internet Archive, 2026 · about this archive